Cisco ASR 903 Release Notes page 157

Chapter
Symptom: Traffic gets dropped during egress when service instance is configured.
Conditions: This issue occurs when service instance is configured.
Workaround: Unconfigure the service instance and reconfigure it again.
CSCud90890
•
Symptom: Routing over Trunk EFP over port-channel does not work on member ports associated
with ASIC #1.
Conditions: This issue occurs when a Trunk EFP on port-channel has members on ASIC#1, the
routing traffic does not egress on those ports.
Workaround: There is no workaround.
CSCud90955
•
Symptom: The following console messages are seen whenever BFD session is created or modified.
Jan
Handoff FPGA could encounter MBE,
Jan
FPGA could encounter MBE, check at end of create update BFD session
Jan
Handoff FPGA could encounter MBE,
Jan
FPGA could encounter MBE, check at end of create update BFD session
Conditions: This issue occurs when BFD sessions are created or modified.
Workaround: There is no workaround. This issue has no service impact.
CSCud96604
•
Symptom: On system reset or reload, all traffic on certain Ethernet Flow Point (EFP)s do not egress.
Conditions: This issue occurs when traffic completely stops on certain EFPs.
Workaround: Delete and reconfigure EFPs.
CSCue00049
•
Symptom: Classification does not work properly with non-matching traffic when IP ACL is used.
Conditions: This issue occurs only for class-based ACL match. The ACL class are classified
properly and other classes based on DSCP or class-default do not work
Workaround: There is no workaround.
CSCue10037
•
Symptom: Crash observed on the router.
Conditions: This issue after when CFM is offloaded and MEPs with 3.3ms were scaled on
port-channel with Trunk EFP. This issue occurs after shutdown command followed by a no
shutdown command is executed on the member links of port-channel.
Workaround: Configure around 50-100 CFM sessions.
CSCue11444
•
Symptom: Split horizon configurations does not clear with Layer2 multicast packets.
Conditions: This issue occurs when Ethernet Flow Point (EFP)s with split-horizon are configured.
Workaround: Perform a shutdown followed by no shutdown. Configure EFP first before moving
into split-horizon group.
CSCue16828
•
OL-26630-08
3 06:34:52.481: %HANDOFF_FUD-6-QDR_MULTI_BIT_ERROR_START: SIP1: nile_mgr:
3 06:34:52.481: %HANDOFF_FUD-6-QDR_MULTI_BIT_ERROR_END: SIP1: nile_mgr:
3 06:34:53.167: %HANDOFF_FUD-6-QDR_MULTI_BIT_ERROR_START: SIP0: nile_mgr:
3 06:34:53.167: %HANDOFF_FUD-6-QDR_MULTI_BIT_ERROR_END: SIP0: nile_mgr:
check at start of create update BFD session
check at start of create update BFD session
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.8S Releases
Handoff
Handoff
15