What To Do If A Fault Condition Occurs; Other Led Indications - Zeta SP-64,126 User Manual, Maintenance Manual & Log Book

SIMPLICITY USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Earth Fault
The Earth Fault LED lights when the panel detects an earth fault (short circuit to earth) on the wiring to any part of the
control panel. The panel will function correctly with a single earth fault, but if a second fault occurs it could damage the
panel. The screen will show Positive or Negative to help the engineer locate the problem.
Sounder Fault
If there is a fault on the loop sounders, the line sounder fault LED will light along with the zone that contains that sounder.
Because the sounder is addressable, any fault will be indicated as a device fault.

6.2 WHAT TO DO IF A FAULT CONDITION OCCURS

If a fault occurs, the responsible person should:
•
Turn keyswitch to Controls enabled and press silence flt tone button to silence the fault buzzer.
•
Write down the fault (s) in the Log Book at the back of this Manual. Take appropriate action to correct the fault
(Usually by contacting the service engineer)
On the Simplicity panel, the fault indications (except system fault) are non latching. That is, when the fault has been
cleared, the fault indication will turn off. When all faults have been cleared, the panel will return to its quiescent (normal)
condition.
When a fault has been rectified the indicator light for that Fault is automatically turned off. If all Faults are cleared, the
General Fault light will go out and the Panel's Internal Sounder will be silent (if not already muted).

6.3 OTHER LED INDICATIONS

DISABLEMENTS
TEST MODE
Approved Document No: GLT.MAN-108
Issue: 2.00 Authorised: GH Date: 04/06/2007
***
Earth Fault Pos
LED ON
LED OFF
*** Device Fault ***
Corridor Sounder 1
Zone:01
LED ON
LED OFF
LED ON
LED OFF
LED ON
LED OFF
FAULT ***
1 of 1
1 of 1
Ad:012
PAGE 9