What To Do If A Fault Condition Occurs - Zeta ID2/2 User Manual

INFINITY ID2 USER MANUAL, MAINTENANCE GUIDE & LOG BOOK

6.2 WHAT TO DO IF A FAULT CONDITION OCCURS

If a fault occurs, the responsible person should:

Enter access code 123 to enable controls and press silence buzzer button to silence the fault buzzer.

Write down the fault (s) in the Log Book at the back of this Manual. Take appropriate action to correct the fault (Usually by
contacting the service engineer)
On the Infinity ID2 panel, the fault indications (except system fault) are non latching. That is, when the fault has been cleared, the
fault indication will turn off. When all faults have been cleared, the panel will return to its quiescent (normal) condition.
When a fault has been rectified the indicator light for that Fault is automatically turned off. If all Faults are cleared, the General Fault
light will go out and the Panel's Internal Sounder will be silent (if not already muted).
Approved Document No: GLT2-211-7-2
Issue 1.00 Author: NRPJ Date: 23/1/2013
Software Versions: PANEL 0.X – R8629 & LOOP 0.J-R624
PAGE 9