Table of Contents
Advertisement
Replacing brake
1.
disCoNNECt lathE FroM poWEr!
2.
open the end-gear cover.
3.
remove the hex nuts and screws that attach
the brake band to the pedal bolt and end
block shown in figure 138.
Brake Band
hex Nuts
hex Nuts &
screws
Brake Bracket
figure 138. Brake replacement components.
4.
remove the hex nuts and screws that attach
the lower part of the brake band to the brake
bracket (see figure 138), then remove the
brake band.
5.
install the new brake band on the brake brack-
et with the screws and nuts you removed in
Step 4.
6.
pull the brake band over the drum and attach
it to the pedal bolt with the screws, end block,
and hex nuts removed in Step 3.
refer to Adjusting brake subsection to ten-
sion the brake.
-84-
screws
End
Block
pedal
Bolt
Gap insert Removal
& installation
the gap insert directly under the spindle (see
figure 139) can be removed to create additional
space for turning large diameter parts.
the gap insert was installed, then ground flush
with the bed at the factory to ensure a precision
fit and alignment. therefore, if the gap insert is
removed, it may be difficult to re-install with the
same degree of accuracy.
gap insert
figure 139. gap insert.
Tools Needed:
open-End Wrench 14mm .................................. 1
hex Wrench 10mm ............................................ 1
heavy dead Blow hammer ............................... 1
slide hammer w/M8-1.25 handle End thread .. 1
Gap Removal
1.
remove the four gap-bed cap screws, shown
in figure 140.
pre-load Bolts
dowel pin
figure 140. Fasteners holding gap in place.
Model G0746/G0749 (Mfg. Since 3/13)
Qty
gap-Bed
Cap screw
Advertisement
Table of Contents
