Table of Contents
Advertisement
Tensioning &
Replacing belt
the pulley system that allows the Model g0842 to
operate at multiple speeds also keeps the V-belt
properly tensioned. however, if the V-belt shows
signs of cracking, splitting, or any other damage,
we recommend you replace it to ensure optimum
power transmission.
Tool Needed
phillips head Screwdriver #2 ............................ 1
To tension and replace v-belt:
1.
diSConnECt MaChinE FroM poWEr!
2.
remove belt access cover (see figure 61).
Belt access
Cover
figure 61. location of belt access cover.
-44-
3.
Move spindle speed lever all the way right to
loosen spindle pulley plates (see figure 62).
Spindle Speed
figure 62. Spindle lever turned right.
4.
pull outer motor pulley plate away from motor
so V-belt slips down to motor arbor, as shown
in figure 63.
5.
While keeping tension off V-belt, roll it off
spindle pulley and remove it (see figure 63).
figure 63. removing V-belt from spindle pulley.
6.
install new V-belt by reversing Steps 4–5.
7.
re-install belt access cover before recon-
necting machine to power.
Model G0842 (Mfd. Since 04/18)
lever
Advertisement
Table of Contents
