Remove Shipping Strap - Kenmore Three-Speed Automatic Washers Owner's Manual & Installation Instructions

Three-speed automatic washers with triple smart dispenser
Table of Contents

Advertisement

B. REMOVE SHIPPING STRAP
W_0jiiFm_" :I_l =[31t"
Removing the shipping strap is
necessary for smooth operation.
If the shipping strap is not removed,
the washer will make excessive noise.
To prevent floor damage, set washer
onto cardboard before moving across
floor. Move washer close to its final
location.
STEP 1. Do not cut yellow strap, Pull
yellow strap firmly, until completely
removed from washer. Depending on
your model, there should be either two
or three cotter pins on the end of the
shipping strap when it is pulled out of
the washer. The electrical plug is
attached to this shipping strap.
Electrical plug
Shipping strap
PULL
Pin
STEP 2. Pull firmly to remove the end
of the shipping strap that remains
pinned to the back of the washer, This
will release the rear self-leveling legs.
Pin
STEP 3. Cut the shipping strap about
16 in (40 cm) from plug end. Look for
the words "CUT HERE." Discard end
with the cotter pins. Slide remainder
of shipping strap from the electrical
plug, You will use this to secure the
drain hose.
Page 14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite three-speed automatic washers

Table of Contents