Remove Shipping Strap - Kenmore Electronic Three-Speed Automatic Washers Owner's Manual & Installation Instructions

B. REMOVE SHIPPING STRAP
IVt,J,i'm,_-" "-I_ =[=:J[i"
Removing the shipping strap is
necessary for smooth operation,
If the shipping strap is not
removed, the washer will make
excessive noise,
To prevent floor damage, set washer onto
cardboard before moving across floor.
Move washer close to its final location.
STEP 1. Do not cut yellow strap. Pull
yellow strap firmly, until completely
removed from washer. Depending on
your model, there should be either two
or three cotter pins on the end of the
shipping strap when it is pulled out of
the washer, The electrical plug is
attached to this shipping strap.
Electrical plug
STEP 2. Pull firmly to remove the
other end of the shipping strap pinned
to the back of washer. This will
release the rear self-leveling legs.
L
STEP 3. Cut the shipping strap about
16 in (40 cm) from plug end. Look for the
words "CUT HERE." Discard end with the
cotter pins. Slide remainder of shipping
strap free from the electrical plug. You
will use this to secure the drain hose.
\
ippingstrap
PULL
Pin
14