Duerkopp Adler 512/532 Operating Manual page 40

Error message Description
E 7 3 6 Error motor speed
E 7 3 7 Error Z phase
E 7 3 8 Error Z phase
E 9 0 7 Error search
X axis
E 9 0 8 Error search
Y axis
E 9 1 0 Error
Clamp foot search
E 9 1 1 Error clamp foot
motor
E 9 1 3 Error
Thread catcher
search
E 9 1 4 Error
Thread catcher
motor
38
Potential cause
Motor stops after some
time/encoder has no signal
Z signal not changing
Z signal imprecise/encoder
has no signal
X axis sensor not respond-
ing
Y axis sensor not respond-
ing
Clamp foot sensor not
responding
Clamp foot motor not run-
ning correctly
The thread catcher sensor
is not responding
Thread catcher motor not
running correctly
Settings via software
Remedy
• Check encoder/motor
• Check encoder/motor
• Check encoder/motor
• Main switch OFF.
• Check sensor.
• Main switch OFF.
• Check sensor.
• Main switch OFF.
• Check sensor.
• Main switch OFF.
• Check motor and connection.
• Main switch OFF.
• Check sensor.
• Main switch OFF.
• Check motor and connection.
Operating manual 512/532 Version 01.0 - 03/2013