Snmp Group - TP-Link TL-SG2424P User Manual

11.1.3 SNMP Group

On this page, you can configure SNMP Group to control the network access by providing the users
in various groups with different management rights via the Read View, Write View and Notify View.
Choose the menu SNMP→SNMP Config→SNMP Group to load the following page.
The following entries are displayed on this screen:
Group Config

Group Name:
Security Model:
Security Level:
Read View:
Figure 11-5 SNMP Group
Enter the SNMP Group name. The Group Name, Security
Model and Security Level compose the identifier of the SNMP
Group. The Groups with these three items the same are
considered to be the same.
Select the Security Model for the SNMP Group.
v1: SNMPv1 is defined for the group. In this model, the

Community Name is used for authentication. SNMP v1
can be configured on the SNMP Community page directly.
v2c: SNMPv2c is defined for the group. In this model, the

Community Name is used for authentication. SNMP v2c
can be configured on the SNMP Community page directly.
v3: SNMPv3 is defined for the group. In this model, the

USM mechanism is used for authentication. If SNMPv3 is
enabled, the Security Level field is enabled for
configuration.
Select the Security Level for the SNMP v3 Group.
noAuthNoPriv: No authentication and no privacy security

level is used.
authNoPriv: Only the authentication security level is used.

authPriv: Both the authentication and the privacy security

levels are used.
Select the View to be the Read View. The management access
is restricted to read-only, and changes cannot be made to the
assigned SNMP View.
126