Procedure For A Navigation Remote Controller - Daikin DCM601A72 Installation Manual

4.1.2

Procedure for a navigation remote controller

The following describes how to assign a DIII-NET address when a navigation remote
controller is installed.
NOTE
You cannot perform the following procedure when the display backlight is off. In this
case, press any key to turn on the backlight before starting the procedure.
1. Press and hold the Cancel button for 4 seconds or more.
The "Field setting" menu is displayed.
<Step 1>
2. Using the Up/Down buttons, select "Group No. setting" and press the Menu/Enter but-
ton.
The "Group No. setting" menu is displayed.
<Step 2>
NOTE
The "Group No. setting" menu is not displayed when the intelligent Touch Manager is
not powered on. Power on the intelligent Touch Manager and wait for a while before
trying to operate the remote controller. The "Group No. setting" menu is not displayed
also when the intelligent Touch Manager is not communicating with the indoor units
normally. Make sure that the cables are connected correctly.
3. Using the Up/Down buttons, select "Group No. setting (Group)" and press the Menu/
Enter button.
The current address setting is displayed.
<Step 3>
28
00 00
Cool
Set temp Room
86
86
F
F
F i e l d s e t t i n g 1/2
Test operation ON/OFF
Register Ser vice Contract
F i e l d s e t t i n g l i s t
Group No. s e t t i n g
Indoor unit Air net No. set
Error record
Retur n Setting
Group No. s e t t i n g
Group No. s e t t i n g (Group)
Group No. s e t t i n g ( U n i t )
Retur n Setting
Installation Manual 3P291714-4
DCM601A72 iTM plus adaptor
English