™
ZonePRO
Section 4
Detailed Parameters
4.8 - Notch Filters (Insert Module)
The notch filter is the perfect tool for dropping out undesirable frequencies that may appear in
the input signal.
Notch On/Off
Turns the notch filters on and off.
Frequency (1 to 6) 20 to 20K
Selects the desired notch filter frequency of the selected notch filter.
Q 16 to 128
Selects the Q of the selected notch filter.
Level -36 to 6 dB
Sets the level of the selected notch filter. Set to +6dB to help find unwanted feedback, then set
to -3dB to -36dB to remove.
4.9 - Router/Mixer
The Router or Mixer (selected in setup) module is the heart of the ZonePRO device and allows
for a primary source, a priority override sources and a paging source, where the paging source
has the highest priority. Both priority override and page have duckers that allow them to duck
the previous sources.
ZonePRO
™
User Manual
28