Table of Contents
Advertisement
Installation
Instructions
[STEP_3]
REMOVE TOEKICK
• Remove the
_
_/J_//_
2toekick screws
__,4/'J_
'
andtoekick.
_
_
i" .,_,/_/
Set aside for use
_L_-_------K//Remove 2
in Step 18.
Figurel
_"_1] ToekickScrews
I STEP 41 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
Use Power Cord Kit WX09X70910, available for
purchase from an authorized GE Appliance Dealer.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Maximum power cord
length is 6 feet.
A
C
Remove
InsertPower
JunctionBox
CordWiresThr
Cover
StrainRelief
andTighten
White
Ground
B
CheckThatWhite, Blackand
GreenDishwasher Wires AreThreaded
ThruSmall Holein Bracket
FigureJ
D
UseULListed
Wire Nuts
• Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed
wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
ISTEP 51 INSTALL 90 °
Frontof Dishwasher
ELBOW
• Wrap 90° elbow with
thread sealtape.
_q_
_-
•
0
Install a 90 elbow onto
/_/_=___
_
the water valve
i_1i
B_ _
......
•
'
Ivl _
_Watervatve
•
Do notovertlghten
/ I /
/
_
_
Bracket
90° elbow. Water
90o _
_/_q_
valve bracket could
Elbow/o/_L_
_
rll
....
1011_ "_"/
I_ Fill
bendorwatervalve
/0/_-J
/
I I H°se
fitting could break.
_/_
' '
• Position the end of the
_k,___J-_
elbow to face the rear
ThreadSeal
Tape
of the dishwasher.
Figure K
[STEP 5A] INSTALL DRAIN HOSE
TO DISHWASHER
DRAIN PORT
Skip this step if drain hose has been pre-installed.
In this step you will need the drain hose set aside
prior to Step 1.
• Stand dishwasher upright.
• Remove hose clamp attached to drain hose. Place
hose clamp over the small end of the drain hose.
Tip: Prevent drain hose damage and possible leaks.
Be careful notto nick or cut the drain hose.
• Push the small end of the drain hose over the drain
port of the dishwasher, see Figure L.
• Make sure hose is fully seated on the dishwasher
drain port.
• Position hose clamp againstthe front lip of the drain
hose and tighten clamp.
HoseClarr
FigureL
DrainHose
-_ Hint: for leak free connections:
• Insert hose against stop on pump.
• Position clamp against front lip of drain hose.
• Tighten clamp to at least 15 inch-pounds of torque.
FrontLip
of Hose
FigureM
6
Advertisement
Table of Contents
