Table of Contents
Advertisement
Installation
Instructions
ISTEP 141 CONNECT
DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES,
Identify the type of drain hose you have. The molded
end of the drain hose will fit 5/8" through 1" diameter
inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if
required, to fit the inlet port.
Type 1
Cutting Line
/
S
/.
IMPORTANT:Do not cut corrugated
portion of hose
Type 2
FigureY
Cutting Lines
/.
IMPORTANT:Do not cut corrugated
portion of hose
• If a longer drain hose is required, add up to 42" of
length for a total of 10' to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection
with hose clamps.
Hose Clamp
Figure Z
Coupler
Hose Clamp
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LEN6TH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1 - Air gap with waste tee or disposer
___
_
_._
A
Waste Tee Installation
Disposer Installation
FigureAA
Method 2 - "High drain loop" with waste tee or disposer
Fastento underside
1_
of countertop
Fasten to underside
_ _
of countertop,
32 _
Waste Tee Installation
Disposer Installation
FigureBB
IMPORTANT-
When connecting drain line to
disposer, checkto
be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN IF PLU6 IS
LEFT IN PLACE.
[_
Remove
Hopper
Plug
TIP: Avoid unnecessary service call charges. Always be
sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
10
Advertisement
Table of Contents
