Table of Contents
Advertisement
Installation
Instructions
ISTEP 171 DISHWASHER
WET TEST
[] Turn on power supply (or plug power cord into
outlet, if equipped),
[] Latch door.
[] Push "Rinse Only" button.
[] Push start/reset pad once. Dishwasher should start.
[] Checkto be sure that water enters the dishwasher.
If water does not enter the dishwasher, checkto be
sure that water and power is turned on.
[] Check for leaks under the dishwasher, If leak is
found, turn power supply off, then tighten connec-
tions. Restore power after leak is corrected,
[] Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinets, Reposition the dish-
washer if necessary. See Step 12.
[] The dishwasher will drain and turn off about 5
minutes after itwas started. Check drain lines. If
leaks are found, turn power off atthe breaker,
correct as necessary, Restore power after correc-
tions are made. See Step 5A and 14.
[] Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14.
[] Press Start/Reset pad once again and run dish-
washer through another "Rinse Only" cycle, Check
for leaks and correct if required.
[STEP 181 REPLACE TOEKICK
• Place toekick against the legs of the dishwasher,
FigureDD
• Align the toekick with the bottom edge and make
sure it is against the floor.
• Insert and tighten the two toekick attachment
screws. The toekick should stay in contact with the
floor.
TIP: Make sure toekick is against floor to minimize
noise.
lSTEP
19] LITERATURE
• Be sure to leave complete literature package and
Installation Instructions with the consumer.
SPECIFICATIONS
SUBJECT T OCHANGE WITHOUT NOTICE
No,31-30584
]
•No, 206C1559P124J
N.D. 923-41 (11/04}
Advertisement
Table of Contents
