Table of Contents
Advertisement
Installation
Instructions
ISTEP151
CONNECT POWER
SUPPLY
Skip this step if dishwasher is equipped with power
cord. Verify that power is turned off at the source.
If a power cord with plug is used, proceed to Step 16.
• Remove junction box cover.
• Secure house wiring to the back of the junction box
with a strain relief.
• Locate the three dishwasher wires, (white, black and
green) with stripped ends. Insert dishwasher wires
through the small hole in the junction box. Use wire
nuts to connect incoming ground to green, white to
white and blackto black.
• Replace junction box cover. Checkto be sure that
wires are not pinched under the cover.
A
Remove
JunctionBox
Cover
C
InsertPower{
CordWiresThrl
StrainRelief
andTighten
White
Ground
Black
B Check ThatWhite, Blackand
Green Dishwasher Wires Are Threaded
ThruSmallHolein Bracket
D
UseULListed
Wire Nuts
Figure CC
r!,W.'1;i#llk _[€ If house wiring is not 2-wire with
ground, a ground must be provided
by the installer. When house wiring
is aluminum, be sure to use UL Listed
anti-oxidant compound and
aluminum-to-copper
connectors
[STEP 161PRE-TEST
CHECK LIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your warranty.
[] Checkto be sure power is OFF.
[] Open door and remove all foam and paper
packaging.
[] Locate the Owner's Manual in the literature
package.
[] Read the Owner's Manual for operating
instructions.
[] Check door opening and closing. If door does not
open and close freely, check for proper routing of
spring cable over pulley. If door drops or closes
when released, adjust spring tension. See Step 1,
Figure G.
[] Checkto be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Step 8.
[] Check door alignment with tub. If door hits tub,
level dishwasher. See Steps 11 and 12.
[] Pull lower rack out, about halfway. Checkto be
sure it does not roll back or forward on the door.
If the rack moves, adjust leveling legs. See Step 11.
[] Check door alignment with cabinet. If door hits
cabinet, reposition dishwasher. See Step 12.
[] Check that door spring does not contact water
line, fill hose, wiring or other components. See
Step 13.
[] Verify water supply and drain lines are not kinked
or in contact with other components. Contact with
motor or dishwasher frame could cause noise.
[]
[]
[]
[]
Turn on the sink hot water faucet and verify water
temperature.
Incoming water temperature
must
be between 120°F and 150°F min. temperature
is
required for best wash performance. See "Prepare
HotWater
Line," page 5.
Add 2 quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
Turn on water supply. Check for leaks. lighten
connections if needed.
Remove protective film if present from the control
panel and door.
11
Advertisement
Table of Contents
