GE PDW7300N10WW Installation Instructions Manual page 7

Built-in dishwasher
Hide thumbs Also See for PDW7300N10WW:
Table of Contents

Advertisement

Installation
Instructions
ISTEP61
POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.
FigureN
Water
Line
Wiring
i
i
ISTEP 71 INSTALL DRAIN HOSE,
THROUGH CABINET
• Position dishwasher in front of cabinet opening,
Insert drain hose into the hole in cabinet side. If a
power cord is used, guide the end through a
separate hole.
MaximumDrain Hose
Length 10'
Insulation
Hose
House
Wiring
PowerCord
(If Used)
Figure 0
Tip: Position water line and house wiring on the floor
to avoid interference
with base of dishwasher,
ISTEP 81 SLIDE DISHWASHER
PARTIALLY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a
time.
Do Not PushAgainst
Front Door Panel With
Knee. Damage to The
Figure P
Door Panel Will Occur.
• As you proceed, pull the drain hose through the open-
ing under the sink. Stop pushing when the dishwasher
is a few inches forward of adjacent cabinets,
• Make sure drain hose is not kinked under the dish-
washer and there is no interference with the water
line and wiring or any other component,
ISTEP 91
INSTALL TRIM PIECES
Skip this step if trim is not supplied with the
dishwasher,
• Locate trim strips inside dishwasher.
• Press trim onto the tub flange on each side. Start with
the top edge, pressing on as you move towards the
bottom.
• Press the two top trim pieces on each side of the latch.
• Open and close the door to check thattrim
does not
bind and does not interfere with door latch.
Trim Strip
Strip
Figure Q
7

Advertisement

Table of Contents
loading

Table of Contents