Connecting Your Ta128 To The Power Supply; Connecting The Ta128 To Your Computer - ZyXEL Communications omni TA128 User Manual

Connecting Your TA128 to the Power
Supply
To Connect your TA128 to the power supply, follow the steps
given below:
1. Turn off your computer.
2. Make sure the power switch on the TA128 is in the OFF
(down) position.
3. Connect the round end of the power adapter to the POWER
JACK on the TA's back panel.
4. Plug the power supply unit to an AC wall jack then power on
the TA128.
5. Observe the LED light status on the front panel of your TA128
and make sure PWR LED is on.
: Use only the power adapter supplied with your TA. Never use a
O O
NOTE
power adapter designed for a different product.

Connecting the TA128 to Your Computer

Your TA128 comes with a 25 pin, male to female cable, which is to
be used to connect the main serial port of TA128 to your computer
serial port as seen in the figure below:
6