Dialing Out For Analog Adapter Port 1; Dialing Out For Analog Adapter Port 2; Manually Switching Communication Modes - ZyXEL Communications omni TA128 User Manual

(ATS83.7=1). This function is useful in the areas where ISDN
service providers charge lower usage rate for voice (speech) calls.
To enable this function, type:
ATS83.7=1<enter>
To disable it, type:
ATS83.7=0 <enter>

Dialing out for Analog Adapter Port 1

Using the "A" command following the "ATD" will tell your
TA128 to automatically switch call to analog adapter, Phone 1,
once dialing is complete.
Type:
ATDA17146930762<enter>
: You must have an analog modem connected to your analog port
O O
NOTE
before you issue this command.

Dialing out for Analog Adapter Port 2

Using the "B" command following the "ATD" will tell your TA128
to automatically switch calls to analog adapter Phone 2, once
dialing is complete.
Type:
ATDB17146930762<enter>

Manually switching communication modes

The manual switching functions will only be necessary if your
communication software does not allow you to change your dial-
up string.
Conventional dialing commands: ATD, ATDT and ATDP, used by
many existing communication software, can be mapped onto one
of the new dialing commands according to the AT&O setting as
follows:
20