Setting And Modifying Passwords - ZyXEL Communications omni TA128 User Manual

Password Check
CPN Check OK
and S119.6=0
CPN Check OK
and S119.6=1
CPN unmatched
CPN not
Available
AT Commands

Setting and Modifying Passwords

Up to 40 user passwords can be defined using the AT*Hn
command, where "n" represents the index to the entry. Numbers
between 0-39 are accepted.
The corresponding 40 call-back numbers are defined by
AT&Zn=xxx command, where "n" represents the index to the
entry, and "xxx" represents the assigned call-back phone number.
Any character (ASCII 0-127) can be used in the password table, the
maximum password length is 8 characters for each entry.
Security functions are only accessible through AT commands in
terminal mode. A supervisory password is required for adding or
modifying entries. The default supervisor password is ZyXEL
90
Level 1 Level 2
Yes Yes
N/A Call back
N/A Keep the
connection
N/A Disconnect
N/A Call back using
the
corresponding
pre-stored
number
*G1 for *G2 for Type 1
Type 1 *G4 for Type 2
*G3 for
Type 2
Level 3
Yes
Prompts
the remote
user to
enter call
back
number
for calling
back.
*G5 for
Type 2