Windsor Chariot iScrub CSX24 Operating Instructions Manual page 52

Maintenance
PROBLEM
Vacuum motor does not run, or
runs slowly
Squeegee will not go up/down
Poor scrubbing performance
Little or no solution flow to the
floor
Brush motors do not run, or run
slowly
Scrub deck goes down, then
raises
52
CAUSE
Faulty vacuum circuit or switch
Worn vacuum motor brushes
Faulty circuit or actuator
Faulty cables or pulleys
Debris caught in scrub brushes
Worn brushes or pads
Improper detergent, brush or pad used
Low scrub brush down pressure
Low battery charge
Solution tank empty
Solution strainer plugged
Solution system plumbing obstructed
Pump obstructed
Solution solenoid valve obstructed or
stuck
Solution shut-off valve is closed
Faulty pump circuit or pump
Faulty solenoid
Circuit breaker(s) tripped
Low battery charge
Faulty brush circuit or motor
Worn brush motor brushes
Faulty actuator circuit or actuator
No brushes or pad drivers on machine
86317500 CHARIOT SCRUBBER
SOLUTION
Check wires & connections
Replace brushes, check commutator
Check wires, connectors and actuator
Repair/replace cables or pulleys
Remove debris
Replace brushes or pads
Contact equipment or application
specialists
Increase brush pressure
Charge batteries
Fill solution tank
Clean solution strainer
Clear obstruction from plumbiing
Clean or replace pump
Solution solenoid valve obstructed or
stuck
Open shut-off valve
Check wiring, connections, and pump.
Check solenoid valve
Reset circuit beaker(s)
Charge battery
Check wires, connections and motor
Replace brushes, check commutator
Faulty actuator circuit or actuator
Install brushes or pad drivers