Windsor Chariot 3 iScrub 26 Operator's Manual

WINDSOR

MAINTENANCE

86372430

04)

Clean squeegee assembly

and inspect the blades. If

the squeegee is damaged or

worn, flip the blade or replace

01) Drain and rinse recovery

and solution tanks. Vent

the recovery lid for stor-

age.

05) Remove and inspect pad or

brushes to clean and replace

as necessary.

hariot

02) Clean and rinse recovery

tank

06) Take a clean rag and wipe

down the exterior of the

machine and vent tank lid

for storage.

Crub

03) Inspect solution filter and

clean as needed.

07) Plug the batteries back

into the charger and

maintain if necessary.

Table of Contents

Do you have a question about the Chariot 3 iScrub 26 and is the answer not in the manual?

Page 1 WINDSOR hariot Crub 01) Drain and rinse recovery 02) Clean and rinse recovery 03) Inspect solution filter and and solution tanks. Vent tank clean as needed. the recovery lid for stor- MAINTENANCE age. 86372430 05) Remove and inspect pad or...
Page 2 WINDSOR WINDSOR hariot Crub 01) Unplug the batteries from Make sure that the solution Fill solution tank with water and measured chemicals. If equipped with the charger and plug the tank cap and recovery lid are chemical metering fill it with desired closed properly and make sure batteries into the machine.
Page 3 WINDSOR WINDSOR hariot Crub 08) Overlap 2-3” on every pass. 09) IN CASE OF EMERGENCY: press the red button to stop the machine. MAINTENANCE OPERATION 00000000 86372430...