Table of Contents
Advertisement
Turning power ON
■
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 17)
Rotate [VOL] to turn the power ON.
q
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad can be used for password input depending on ver-
sion:
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identi-
cal. Therefore "01234" and "56789" are the same.
[VOL]
[Side3]
NUMBER
[P0]/[P1]/
[P2]/[P3]
e When the "PASSWORD" indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
KEY
Side3
0
1
2
3
4
5
6
7
8
9
BASIC OPERATION
D
Battery type selection
The battery type must be selected according to the attaching
battery type when turning the transceiver ON.
Ask your dealer for details.
Turn the power OFF.
q
While pushing and holding [Emer] and [PTT], turn the
w
power ON with rotating [VOL] to toggle the attaching bat-
tery type.
• After the display appears, release [Emer] and [PTT].
• "DRY BATT" is displayed for about 3 seconds then "L" appears
when the battery case operation is selected. In this case, the
transmit output power is low.
• "LI-ION" is displayed for about 3 seconds when the Lithium-ion
battery operation is selected.
[VOL]
[Emer]
[PTT]
3
Appears
Dry battery mode
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
8
Advertisement
Table of Contents
