Loading The Rom File; Configuring The Vlan - Yealink SIP-T2xP Administration Manual

To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the phone and an
available port on the in-line power switch/hub.
If in-line power is provided, you don't need to connect the AC adapter. Make sure the
Note
Ethernet cable and switch/hub are PoE compliant.
The IP phone can also share the network with other network device such as a PC
(personal computer). It is an optional connection.
Important! Do not unplug or remove power while the IP phone is updating firmware and
configuration.
The initialization process of the IP phone is responsible for network connectivity and
operation of the IP phone in your local network.
Once you connect your phone to the network and to an electrical supply, the phone
begins its initialization process.
During the initialization process, the following events take place:

Loading the ROM file

The ROM file resides in the flash memory of the IP phone. The IP phone comes from the
factory with a ROM file preloaded. During initialization, the IP phone runs a bootstrap
loader that loads and executes the ROM file.

Configuring the VLAN

If the IP phone is connected to a switch, the switch notifies the IP phone of the VLAN ID
defined on the switch. The IP phone can then proceed with the DHCP request for its
network settings (if using DHCP).
Getting Started
15