Setup And Installation For Novell Netware - Intel U3-1L Quick Start Manual

d. When setup is complete a message will pop up indicating that a reboot
is necessary and give a choice to "reboot now" or "reboot later".
e. Remove the CD-ROM from the CD ROM drive and select "reboot
now". The system MUST be rebooted immediately after installation
of the RAID Software Suite.
f. Windows 2000 (only): After the system reboots a message will pop
up indicating that a new device has been found. Use the "Browse"
option point to the <system drive>:\Program Files\RAID Software
Suite\Drivers and select the "I2Odisk.inf" file. This will install the
device driver for the RAID volume itself. A message will prompt for
a reboot. Reboot the system to complete the installation.
NOTE
Refer to the user's manual for information on HP Openview and RAID
Monitor, SNMP, DMI components or remote storage console. Also see the
user's manual for instructions on customizing your RAID volumes using
Storage Console.
Setup and Installation for Novell
Software Requirements
SRCU31L CD-ROM
Hard disk space: minimum 4 MB
†
MS-DOS 5.x or later (Novell 4.2 only)
SRCU31L NetWare Installation Diskette (one blank high density floppy
diskette required)
Novell NetWare 4.2 with Service Pack 8a or higher or Novell NetWare 5.0
or 5.1 with Service Pack 4 or higher
* Not supplied
Installing Novell NetWare on a RAID Volume
There are two procedures listed below (one for each supported version of
NetWare). Please follow the instructions for the version you wish to install
(version 4.2 or 5.0 and 5.1).
NetWare 4.2
1 Create a SRCU31L NetWare Installation Diskette.
a. Insert the Intel Integrated RAID CD-ROM into the target system and
restart the system to boot from the CD-ROM.
b. When the ROM-DOS Startup Menu appears select option #1, Make
Diskettes.
c. When the Select a diskette to create screen appears, select NetWare
Installation. A command window appears.
12
† †
NetWare
*
Intel Server RAID Controller U3-1L (SRCU31L)
Quick Start Guide