Table of Contents
Advertisement
4
Press either the + or – button to move the B
(cursor), and select a configuration number.
5
Press and hold the + and – buttons simultaneously
for more than 2 seconds.
The information (present state) screen appears.
Example when "2" is selected:
Configuration number 2 is selected.
Notes
• The configuration cannot be switched simply by
moving the B (cursor). In order to apply the
change, press and hold the + and – buttons for
more than 2 seconds after moving the cursor.
• The setting change will be canceled if there is no
menu operation for more than 15 seconds.
6
Press either the + or – button to close the
information screen and exit the setting.
24
Operating the Menu with No Image Input
r
r
Operating the Menu with
No Image Input
If no signal is input, the unit usually enters the standby
mode due to the power management function. Normal
power can be temporarily restored for menu operations
by the following method.
Displaying the menu screen
1
In the standby mode (the LED indicator of the 1
(standby) switch is lit in amber), press and hold the
+ or – buttons on the rear panel simultaneously for
more than 2 seconds.
The LED indicator lights up in green and the
information screen appears.
You can change the following settings from the menu.
SWITCHING EDID
"Fixing the Display Orientation" (page 20)
SWITCHING DISPLAY MODE
"Switching the Display Mode" (page 21)
SWITCHING INPUT SOURCE
"Switching the Input Source" (page 22)
SWITCHING CONFIGURATION
"Switching Configuration Data" (page 23)
Note
The power only turns on momentarily, then the standby
mode is entered. If you happen to enter the standby
mode during menu operation, perform step 1 again.
About the power management function
The unit enters the standby mode if no signal input is
detected to reduce power consumption.
LED indicator
Advertisement
Table of Contents
