Table of Contents
Advertisement
Note
Do not connect or disconnect the cable during operation,
as this could damage the graphics card.
Turn off the system before connecting or disconnecting
the cable.
Switching Configuration Data
The unit can save up to three sets of settings (luminance/
gamma), which can be called up by selecting a
configuration number on the SWITCHING
CONFIGURATION screen.
The following three configurations are saved as the
factory default. The default setting is "1."
Follow the instructions below to switch the
configuration data.
LMD-DM50/DM30
Luminance (cd/m
Configuration
number
Max.
Min.
1
410
0.8
(default)
2
410
1.0
3
500
0.8
LMD-DM20
Luminance (cd/m
Configuration
number
Max.
Min.
1
410
0.8
(default)
2
500
0.8
3
410
0.8
Note
To set and save configurations other than above, the
optional calibration kit is required.
Switching configuration data
1
Press either the + or – button on the rear panel.
The information (or present operating state) screen
appears.
Pressing either button repeatedly changes the
display as follows: Information t present
operating state t display off.
2
)
Gamma
Ambient
Light
0.0
DICOM
GSDF
0.0
DICOM
GSDF
0.0
DICOM
GSDF
2
)
Gamma
Ambient
Light
0.0
DICOM
GSDF
0.0
DICOM
GSDF
0.0
Gamma
2.2
The information screen automatically turns off
after about 15 seconds.
2
With the above screen displayed, press and hold the
+ and – buttons simultaneously for more than 2
seconds.
The SWITCHING INPUT SOURCE screen
appears.
3
Press the 1 (standby) switch on the front panel of
the unit.
The SWITCHING CONFIGURATION screen
appears.
Pressing the 1 (standby) switch repeatedly
switches between the SWITCHING INPUT
SOURCE and SWITCHING CONFIGURATION
screen.
23
Changing the Display Setting
Advertisement
Table of Contents
