Attaching An Arm Stand - Sony LMD-DM20 Instructions For Use Manual

Attaching an Arm Stand

The tilt stand is interchangeable with commercially
available arms that feature the following:
Mount plate with 4 holes at 100 mm × 100 mm.
115 mm (4
100 mm (4 inches)
Load capacity should be at least equal to the
total mass of the LCD panel (without stand) and
connected cables.
For more information, ask the arm maker.
Notes
• Use the original screws to attach the LCD panel on its
original tilt stand again.
• If the screws are too long, they could damage internal
parts. If they are too short, the attachment may become
loose and the LCD panel could fall off.
Choose the screw size carefully according to the plate
thickness.
Mounting plate thickness Screw size
3.5 - 4.5 mm
1.5 - 3.5 mm
Below 1.5 mm
Sony is not liable for any damage or injury resulting
from changing stands.
How to attach an arm stand
1
Place a soft cloth or cushioning material over a
stable, even surface.
2
Put the LCD panel face down on the cushioning
material.
5
/ inches)
8
ISO M4 × 12
ISO M4 × 10 (Originally used)
ISO M4 × 8
3
Remove the 4 screws, using a cross-head
screwdriver, then detach the tilt stand.
Soft cloth or cushioning material
4
Attach the arm stand to the LCD panel, reversing
the procedure above.
Do not try by yourself to attach the LCD panel to an
arm that is already installed somewhere. Ask for
assistance from another person. Tipping over or
dropping the LCD panel could cause damage and/
or injury.
Tilt stand
29
Attaching an Arm Stand