Table of Contents
Advertisement
• The setting change will be canceled if there is no
menu operation for more than 15 seconds.
6
Press either the + or – button to close the
information screen and exit the setting.
To return to the ISD mode, follows the steps above
and select "ISD" on step 4.
About the ISD technology license
To display images with the ISD technology, a license
and a special viewer are required.
When the license is not activated, the DSP MODE is set
as Normal (*), or ISD (*).
When the license is activated, the DSP MODE is set as
Normal, or ISD.
For details, consult your Sony dealer.
Switching the Input Source
Follow the instructions below to switch the input source.
1
Press either the + or – button on the rear panel.
The information (or present operating state) screen
appears.
Pressing either button repeatedly changes the
display as follows: Information t present
operating state t display off.
The information screen automatically turns off
after about 15 seconds.
2
With the above screen displayed, press and hold the
+ and – buttons simultaneously for more than 2
seconds.
The SWITCHING INPUT SOURCE screen
appears.
22
Changing the Display Setting
3
Press either the + or – button to move the B
(cursor), and select an input source.
4
Press and hold the + and – buttons simultaneously
for more than 2 seconds.
The information (present operating state) screen
appears.
Example when "DVI" is selected:
Notes
• The configuration cannot be switched simply by
moving the B (cursor). In order to apply the
change, press and hold the + and – buttons
simultaneously for more than 2 seconds after
moving the cursor.
• The setting change will be canceled if there is no
menu operation for more than 15 seconds.
5
Press either the + or – button to close the
information screen and exit the setting.
Note
The unit automatically detects the input signals. Switch
the input source after receiving the video signal from
that source.
If the unit has one input source only, the unit always
selects that input source regardless of the setting.
Digital input
The unit supports only digital signals. It is normal for
noise to occur during startup, shutdown, and/or when
switching resolutions. This is a result of the graphics
card in the system switching resolution.
Also, when switching resolutions, a white area of 5 mm
× 5 mm may appear near the front sensor. In either case,
it is not a malfunction.
The input source is
switched to "DVI."
Advertisement
Table of Contents
