Table of Contents
Advertisement
6. If the keyboard cable is held in place by a keyboard lock arm next to the keyboard connector, carefully pivot the lock arm upward to uncover the cable.
7. Pull up on the pull-tab to disconnect the keyboard cable connector from the keyboard connector on the system board.
NOTE:
When you replace the keyboard, ensure that the keyboard tabs are completely in place to avoid scratching the palm rest.
Internal Card With Bluetooth® Wireless Technology
CAUTION:
Before performing the following procedures, follow the safety instructions in your Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1. Follow the procedures in
Before You
2. Remove the hinge cover (see
1
card cable
NOTICE:
Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.
3. Carefully remove the card cable from its routing guide.
4. While grasping the card cable with one hand, use a plastic scribe to gently pry the card out from underneath the metal tab with the other hand.
5. Lift the card from the compartment, ensuring that you do not pull on the card cable with excessive force.
6. Disconnect the card from the cable and remove the card from the computer.
Coin-Cell Battery
CAUTION:
Before performing the following procedures, follow the safety instructions in your Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
Begin.
Hinge
Cover).
2
card
3
metal tab
Advertisement
Table of Contents
