Dynamic Route Table; Rip Information - Motorola 68384 - Vanguard 320 Router User Manual

User guide
Table of Contents

Advertisement

S P E C T R U M E n t e r p r i s e M a n a g e r
the IP address is used as the subnet portion, the
address mask would be set to 255.255.255.0.
NextHop
The IP address of the next hop to the destination.
The next hop itself must be on an IP network
directly connected to the router.
Metrics
Enables/disables the inclusion of all subnet
routes within RIP updates sent on this interface.

Dynamic Route Table

This area of the Static Routes Info view lists IP
addresses of destination networks/subnetworks
for dynamic routes. Host addresses are not
included.

RIP Information

This area of the Static Routes Info view displays
the following Routing Information Protocol (RIP)
configuration settings:
RIP Status
Indicates whether RIP processing is globally
enabled/disabled for the router.
Directed Broadcast
Indicates whether forwarding of IP packets whose
destination is a non-local (remote LAN) broadcast
address is enabled/disabled.
IP Access Control
Globally enables/ disables operation of the IP
Access Control table for this router.
Internal NetMask
This IP Address overrides the Router ID to become
the default IP address for the router. The default
IP address is used as the IP source address of
PING and ICMP frames originated from the router.
It is the reported IP address in SNMP trap frames.
If both Router ID and this internal IP address are
left undefined (as 0.0.0.0), the default IP address
is the IP address of the lowest numbered
operational interface of the router.
Route Cache Size
The maximum number of entries that may be
stored in the IP route cache. The IP route cache
holds the destination addresses of recently
received packets and for each entry maintains a
count of packets forwarded to that destination.
Originate Default Route
Indicates whether origination and RIP
advertisement of the default IP route 0.0.0.0. are
enabled/disabled for the router. Default route
advertisements must also be explicitly enabled for
each interface. The router will originate the
default route only when it has EGP-derived or
external OSPF routes in its routing table.
44 of 95
M o t o r o l a V a n g u a r d D e v i c e s

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vanguard 320

Table of Contents