Motorola 68384 - Vanguard 320 Router User Manual page 72

S P E C T R U M E n t e r p r i s e M a n a g e r
Options
Identifies any options in effect for this port. Appli-
cable codes and descriptions for X.25 ports are
listed in the following table.
Table 11: X.25 Port Option Codes
Code
NONE
1980
NUI
PDN
CUD
IBAR
OBAR
CBCK
CUG
CAUSE
Description
No option specified.
Use X.25 1980.
Perform network user ID valida-
tion check.
Connected to Public Data Net-
work.
Use call user data sub-address-
ing.
Bar all calls coming in from X.25
port user.
Bar all calls going out to X.25
port user.
Allow routing inbound calls back
out this port.
Check closed user group; other-
wise, CUG passes transparently.
Pass cause, diagnostic, code in
outbound packets.
Table 11: X.25 Port Option Codes
Code
DEDO
DEGO
REGI
REGO
HOLD
NRST
BKUP
SRGI
INL
INLA
72 of 95
M o t o r o l a V a n g u a r d D e v i c e s
Description
Delete called address from out-
bound calls.
Delete calling address from out-
bound calls.
Replace calling address with con-
figured Port Address in inbound
calls.
Replace calling address with con-
figured Port Address in outbound
calls.
Hold calls over link restart.
Do not send restart packet on
link-up.
This is a backup port to be acti-
vated if other ports are down.
Select route by the calling
address in inbound calls.
Inter-node link. Link goes to
another 6500 device.
Set with INL option when an X.25
link connection is to a 6500 node
using 2.12.04 or earlier.