Grandstream Networks GXV-3000 User Manual page 38

Enable Video
H.264 payload type
H.263+ payload type
H.263 Default Resolution
Enable RFC5168 Support
SRTP Mode
Special Feature
S C
AVING THE ONFIGURATION
After the user makes a change to the configuration, press the "Update" button in the Configuration Menu.
The web browser will then display a message window to confirm saved changes.
Grandstream recommends reboot or power cycle the IP phone after saving changes.
R P
EBOOTING THE HONE
Press the "Reboot" button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.
Grandstream Networks, Inc.
Yes: video is enabled for all calls. This is the default value.
No, but allow in-call enabling :
Receiving call:
There are two ways to pick up incoming video call.
-Pressing SPEAKER or picking up handset will answer the call as VOICE ONLY call.
GXV-3000 can still send out video request after the call is established by pressing MIR-
ROR button.
-Pressing MIRROR button will answer the call as VOICE & VIDEO call.
Making call:
-Picking up handset or pressing SPEAKER
-Pressing MIRROR button to toggle between VOICE ONLY and VOICE & VIDEO
No: video is disabled.
Enter a desired value (96-127) for dynamic RTP payload type of H.264 codec.
Default is 99.
Enter a desired value (96-127) for payload type of H.263+ codec. Default is 103
Default is CIF.
Default is No.
If it is set to Yes, phone will send an SIP INFO asking for update of I-frame.
Enable SRTP mode based on selection. Default is Disabled.
Default is Standard.
Choose the selection to meet special requirements from different Soft Switch vendors (like
Nortel, Broadsoft, Sonus, etc)
C
HANGES
R
EMOTELY
GXV-3000 User Manual
Firmware 1.1.3.50
Page 36 of 54
Updated: 04/2009