Grandstream Networks GXV-3000 User Manual page 35

NAT Traversal (STUN)
Keep-Alive Using SIP OP-
TIONS
Subscribe for MWI
Proxy-Require
SIP Compact Header
Voice Mail User ID
Send DTMF
Early Dial
Dial Plan Prefix
Grandstream Networks, Inc.
This parameter defines whether the NAT traversal mechanism is activated. If activated (by
choosing "Yes") and a STUN server is also specified, then the GXV-3000 will behave ac-
cording to the STUN client specification. Using this mode, the embedded STUN client de-
tects what type of NAT/Firewall router used and displayed the result in Status Page.
If the detected NAT is a Full Cone, Restricted Cone, or a Port-Restricted Cone, the GXV-
3000 will attempt to use its mapped public IP address and port in all of its SIP and SDP
messages.
If the NAT Traversal field is set to "No, but send keep-alive" with no specified STUN server,
the GXV-3000 will periodically (every 20 seconds or so) send a blank UDP packet (with no
payload data) to the SIP server to keep the "hole" on the NAT router open.
If the detected NAT is symmetric NAT, then STUN can NOT be used and an Outbound
Proxy or Session Border Controller must be used and this field must be configured to "NO".
Default is No
Default is No. When set to "Yes" a SUBSCRIBE for Message Waiting Indication will be
sent periodically. GXV-3000 supports both synchronized and non-synchronized MWI.
SIP Extension to notify SIP server that the unit is behind the NAT/Firewall.
Do not configure it unless the server supports this special feature.
Default is No. If set to Yes, the header is sent in compact format. This is helpful in stateless
proxy with multiple codec used as big UDP packet is not router friendly during transit.
When configured, user can access VM messages by pressing "MSG" button.
This ID is usually the VM portal access number, e.g.: 8500 in Asterisk or 8502 for FWD.
This parameter specifies the mechanism to transmit DTMF digit.
There are 3 supported modes: in audio which means DTMF is combined in audio signal
(not very reliable with low-bit-rate codec), via RTP (RFC2833), or via SIP INFO.
Default is No. Use only if proxy or server supports 484 response.
Sets the prefix added to each dialed number.
GXV-3000 User Manual
Firmware 1.1.3.50
Page 33 of 54
Updated: 04/2009