Advertisement
Setting Surface Burners
Setting Double Ring Burner (some models)
The versatile
Double
Ring surface
burner
offers
a complete
range of gas surface
settings from the same burner
position.
At the lowest setting,
only the burner's
inner ring is active,
providing
a smaller
flame
that is perfect
for simmering.
If
needed,
the burner's
outer ring may be added
and when set for
HI will provide
a gas flame
that may be used to bring
a large
pan of liquid
to boil quickly.
Operating
the Double Ring Burner:
1.
Push right front
surface
burner control
knob in and turn
counterclockwise
out of the OFF position.
2.
Release the knob and rotate to the Lite position.
3.
Visually
check
that both
inner and outer
rings for the
Double
Ring burner are lit (Figure 11). Once
lit, push in the
control
knob and to turn counterclockwise
out of the Lite
position
and adjust to the desired
flame
size.
4.
When
adjusting
for a low or simmer
type flame
setting,
continue
to rotate
the control
knob counterclockwise
from
MED setting
towards
LO (Figure 9). Between
the MED and
LO setting
the flame
for the outer ring portion
of the burner
will turn off leaving
only the inner
burner with a flame
for
simmering
(Figure 11). Make
any further
flame
adjustments
as needed.
Figure 11: Burner at highest (L) setting and simmer (R)
Do not place flammable
items such as plastic
salt and pepper
shakers,
spoon holders
or plastic
wrappings
on
the cooktop
when it is in use. These items could melt or ignite.
Potholders,
towels or wooden
spoons could catch
fire if placed
too close to the range
cooktop.
Do not place aluminum
foil, or ANY
material
that can melt on the range cooktop.
If these items melt they may
permanently
damage
the cooktop
surface.
Important:
•
DO NOT cook with the surface
control
knob left in the Lite
position.
The electronic
ignitor
will continue
to spark if the
control
knob setting
remains
in the Lite position.
•
When
setting
any surface
control
knob to the Lite position,
all electronic
surface
ignitors
will spark at the same time.
However,
only the surface
burner
you are setting
will ignite.
•
NEVER place or straddle
a cooking
utensil over two
different
surface
cooking
areas
at the same time. This can
cause uneven
heating
results.
In the event of an electrical
power
outage,
the surface
burners can be lit manually.
Use caution
when lighting
surface
burners manually.
To light a surface
burner, hold a
lit match
to the burner
head, then slowly turn the surface
control
knob to Lite. After burner
lights
push in and turn
knob to desired
setting.
Figure 9: Setting the double ring burner
OFF
_
Ha
•
MED
•
LO
Figure 10: Burner levels
12
Advertisement
