Page 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
Important Notes to the Installer Never leave children alone or unattended 1. Read all instructions contained in these installation in the area where an appliance is in use. As childrengrow, instructionsbefore installingrange. teach themthe proper,safe use ofallappliances. Never leave Remove all packingmaterial fromthe ovencompartments the oven door open when the range is unattended.
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
Page 4
C. Level and Position Range- Level range by adjusting the (4) leveling legswith a wrench. Note:A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use aspirit level to checkyour adjustments.
Page 5
5. Read electrical connection details below Manual Flare Flexible Flare Union Pressure and connect electricity to range. Shu _vOef Union AcPoPnl i_l un c t e Adaptor Regulator Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Reauirements: An individual, properly grounded and Off ServiceShut-Off ValveEl e ctric Ignition m_inly polarized branch circuit protected by a 15 amp.
Page 6
Electric Ignition Surface Burners Operation of Surface Burners Operation of electric ignitersshouldbe checked after range 6, Installation of Surface Burner Caps and supply line connectorshave been carefullychecked for Your range is equipped with any combinationof the sealed leaks and range has been connected to electric power. burners.
appear at the oven burner. There isa time lapse from 30 to 60 8. Adjust the "LOW" Setting of Surface Burner seconds after the thermostat is turned ON before the flame Valve (Linear Flow Valves Only): appears at the oven burner. When the oven reaches the dial setting, the glowing igniter will go off.
Care, Cleaning and Maintenance Oven Refer to the Use & Care Guide for cleaning instructions. Burner Tube If removing the range is necessary for cleaning or maintenance, shut off gas supply. Disconnect the gas and ® electrical supply. If the gas or electrical supply is inaccessible, ®...
This manual is also suitable for:
790756041047907560910479075604102790756021027907560910279075609100...
Show all