Installation Instructions; Tools And Parts; Electrical Requirements - Kenmore 110.6708 Use & Care Manual

INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
• Flat-blade screwdriver • Tin snips (new vent
• #2 Phillips screwdriver installations)
• Adjustable wrench that • Level
opens to 1" (2.5 cm) or • Vent clamps
hex-head socket wrench
(for adjusting dryer feet) • Caulking gun and
compound (for installing
• Wire stripper (for direct new exhaust vent)
wire installations) • Tape measure
Parts supplied:
Remove parts package from dryer drum. Check that all parts
were included.
4 leveling legs
Parts needed:
Check local codes, check existing electrical supply and venting
and see "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-80O-4-MY-HOM E®(1-800-469-4663).
Expmosion Hazard
Keep flammable materials and vapors, such as
gasomine, away from dryer.
Pmace dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Faimure to do so can resumt in death, explosion, or fire.
You will need
• A location that allows for proper exhaust installation. See
"Venting Requirements."
• A separate 30-amp circuit.
• If you are using a power supply cord, a grounded electrical
outlet located within 2 ft (61 cm) of either side of the dryer.
See "Electrical Requirements."
• A sturdy floor to support the total weight (dryer and load) of
200 Ibs (90.7 kg). The combined weight of a companion
appliance should also be considered.
• A level floor with a maximum slope of 1" (2.5 cm) under entire
dryer.
Do not operate your dryer at temperatures below 45°F (7°C). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes or
sleeping quarters. Contact your local building inspector.