Dryer Rack - Kenmore 110.6708 Use & Care Manual

Hide thumbs Also See for 110.6708:
Table of Contents

Advertisement

Available languages

Available languages

Changing
the Preset Dryness Level Settings
If all of your loads on all Auto Dry cycles are consistently
not as
dry as you would like, you may change the preset Dryness Level
settings to increase the dryness. This change will affect all of your
Auto Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different
installations, environmental
conditions
or personal preference,
There are 3 drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately
15% more drying time)
and 3 (much dryer clothes, approximately
30% more drying
time).
1. The Dryness Level settings cannot be changed while the
dryer is running.
2. Press and hold the DRYNESS LEVEL button for 5 seconds.
The dryer will beep, and "CF" will be displayed for 1 second
followed by the current drying setting.
3. To select a new drying setting, press the DRYNESS LEVEL
button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting
will not flash, but the other settings will flash.
4. Press START to save the drying setting.
5. The drying setting you selected will become your new preset
drying setting for all Auto Dry cycles.
The dryer rack was shipped in the dryer drum.
Use the dryer rack for items that you do not want to tumble dry,
such as sweaters.
Use Timed Dry to select the desired time.
NOTE: Do not use Auto Dry Cycles with the dryer rack.
To use the dryer rack:
Do not remove the lint screen.
1. Open dryer door.
2.
Slide dryer rack over the bottom of the dryer door opening.
Rest the back wire on the dryer back ledge.
Push clown on
the frame front to secure
over lint screen.
4. Close the door.
5. Select TIMED DRY and TIME ADJUST MORE TIME or LESS
TIME. Refer to the following table.
6. Select the desired temperature setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber or plastic must be dried on a clothesline or by
using an air cycle. Refer to the following table.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.
Suggested
Items for Rack
Cycle
Suggested
Drying
Setting
Time*
(Minutes)
Washable wool items
Low
20
(block to shape and lay flat
on rack)
Stuffed toys or pillows
Low
30
(cotton or polyester
fiber filling)
Stuffed toys
Air Dry
50
(foam rubber filled)
Galoshes (rubber)
Air Dry
20
Foam rubber pillows
Air Dry
50
Tennis shoes
Air Dry
20
*Reset time as needed to complete drying.
NOTE: You must remove rack for normal tumbling. To remove the
dryer rack, lift it straight up and out of the dryer.
3.
Place wet items on top of the rack. Allow space around items
for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.
23

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

110.6709

Table of Contents