Kenmore 110.6708 Use & Care Manual page 8

Power Supply Cord Direct Wire
Fire Hazard
Use a new UL misted 30 amp power supply cord.
Use a UL misted strain relief,
Disconnect power before making emectrica_ connections,
Connect neutram wire (white or center wire) to center
terminaa (silver),
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 suppmy wires to remaining
2 terminals (goBd).
SecureBy tighten aH emectricat connections,
FaiBure to do so can resumt in death, fire, or
electrical shock,
Fire Hazard
Use 10 gauge somid copper wire,
Use a UL misted strain relief,
Disconnect power before making emectrica_ connections.
Connect neutral wire (white or center wire) to center
terminal (simver).
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 suppmy wires to remaining
2 terminals (goBd).
Securety tighten aH emectrica{ connections.
Failure to do so can resumt in death, fire, or
emectricaI shock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
AB C D
E
F
3. Install strain relief,
Style 1: Power supply cord strain relief
Remove the screws from a 3/4" (1.9 cm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections into the hole below the terminal block opening so
that one tab is pointing up and the other is pointing down,
and hold in place. Tighten strain relief screws just enough to
hold the two clamp sections together.
A. Terminal block cover
B. Hold-down screw
C. External ground conductor screw
D. Center, silver-colored terminal block screw
E. Neutral ground wire
F. Hole below terminal block opening
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down