Safety Notices - NEC HX4500 User Manual

Safety Notices

T
Caution: To reduce the risk of electric shock which could cause
personal injury, follow all safety notices. The symbols shown are
used in your documentation and on your equipment to indicate
safety hazards.
T
Warning: Lithium batteries can be dangerous. Improper handling
of lithium batteries may result in an explosion. Dispose of lithium
batteries as required by local ordinance or as normal waste if no
local ordinance exists.
T
Warning: The detachable power supply cord is intended to serve
as the disconnect device.
T
Warning: This equipment has two 3-wire, grounded power cords.
To prevent electrical hazards, do not remove or defeat the ground
prong on the power cord. Replace the power cord if it gets
damaged. Contact your dealer for an exact replacement.
T
Warning: The DC push-button on/off switch on the front panel
does not turn off the system AC power. Also, +5vdc is present on
the system board whenever the AC power cord is connected
between the system and an AC outlet. Before doing the
procedures in this manual, make sure that your system is powered
off and unplug the AC power cord from the back of the chassis.
Failure to disconnect power before opening your system can result
in personal injury and equipment damage.
In the U.S.A. and Canada, each power cord must be a UL-listed
detachable power cord (in Canada, CSA-certified), type ST or SJT, 16
AWG, 3-conductor, provided with a molded-on NEMA type 5-15 P plug
cap at one end and a molded-on cord connector body at the other end.
The cord length must not exceed 9 feet (2.7 meters).
x Using This Guide
!