A&D AD-4212A-100 Instruction Manual page 58

Transmitting all memory data at one time
Confirm that the "Serial interface ( 5if )" parameters are set properly. For details, refer to "10.
FUNCTION TABLE" and "17. CONNECTION TO PERIPHERAL EQUIPMENT".
1 Press and hold the PRINT key until reCall is displayed, then release the key.
2 Press the SAMPLE key to display
3 Press the PRINT key to display Sout no
5 Press the RE-ZERO key to display out go
6 Press the PRINT key to transmit all data using the RS-232C interface.
7 The balance displays
weighing mode.
Deleting all memory data at one time
1 Press and hold the PRINT key until reCall
2 Press the SAMPLE key several times to display Clear .
3 Press the PRINT key to display SClr no
4 Press the RE-ZERO key to display SClr go
5 Press the PRINT key to delete all data
6 The balance displays
7 Press the CAL key to return to the weighing mode.
out .
with "no" blinking.
Clear when all data is transmitted. Press the CAL key to return to the
with "no" blinking.
end , then reCall when all data is deleted.
56
with "go" blinking.
is displayed, then release the key.
with "go" blinking.