A&D AD-4212A-100 Instruction Manual page 57

The following commands can not be used during data storage.
Q Query command for weighing data.
S Query command for stable weighing data.
SI Query command for weighing data.
SIR Query command for continuous weighing data.
Setting the function table
Parameter settings for each output mode are as follows:
Item
Mode
Key mode
Auto print mode A
Auto print mode B
Interval memory mode
Set each item, depending on the situation, as follows:
Data number No
Yes
ID number No
Yes
With 5-td 1, 5-td 2 or 5-td 3 selected, the amount of data to be stored is 100 sets.
Recalling the memory data
Confirm that the "Data memory ( data )" parameter is set to "2".
1 Press and hold the PRINT key until reCall is displayed, then release the key.
2 Press the PRINT key to enter the memory recall mode. Recall the data in memory using the
following keys
RE-ZERO key
MODE key
PRINT key
With SAMPLE held down, press the CAL key
Note: Deleting the data will not increase the amount of data that can be stored.
CAL key
3 Press the CAL key to return to the weighing mode.
Data output Auto
mode polarity,
difference
prt 0, 4, 5 Not used
prt 1 ap-a 0-2
ap-b 0-2
prt 2
prt 3 Not used
d-no 0
d-no 1
Time and date
5-id 0
5-id 1
To proceed to the next data set.
To go back to the previous data set.
To transmit the current data using the RS-232C interface.
To delete the data currently displayed.
To exit the memory recall mode.
55
print Data memory
function
data 2
data 2
data 2
data 2
No
Time only
Date only
Both
Interval
time
Not used
int 0-8
5-td 0
5-td 1
5-td 2
5-td 3