Kenmore Top-mount Refrigerator Use & Care Manual page 13

Remove and Replace Dispenser Paddle
The removable paddle is designed to catch small spills and allow
for easy cleaning. There is no drain in the paddle. The paddle can
be removed from the dispenser to be emptied or cleaned.
IMPORTANT: Press and hold LOCK OUT for 2 seconds to
activate the dispenser lock feature before removing the dispenser
paddle. See "The Dispenser Lock."
1. Press up on the dispenser paddle, as shown, to release.
The Dispenser Light
The dispenser light turns on automatically when you press the
paddle to dispense water. If you want the light to be on
continuously, press the light bulb button, located on the left-hand
side of the dispenser control panel, for either ON or AUTO.
NOTE: The dispenser lights are LEDs which do not need to be
changed.
ON AUTO
2. Pull down on the dispenser paddle to remove.
3. Replace the dispenser paddle by firmly snapping it into the
dispenser cover as shown.
ON: Press the light bulb button once to turn on the dispenser
light. The green indicator will appear below ON.
AUTO: Press the light bulb button a second time to select the
auto mode. The green indicator will appear below AUTO. The
dispenser light will automatically adjust to become brighter as the
room brightens, dimmer as the room darkens.
OFF: Press the light bulb button a third time to turn the dispenser
light off.
The Dispenser Lock
The water dispenser can be locked for easy cleaning or to
prevent unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product,
to the ice maker, or to the dispenser light. It simply deactivates
the dispenser paddle.
To Lock the Dispenser:
Press and hold the LOCK OUT button for 2 seconds until the red
indicator appears. The water dispenser and the dispenser control
panel will not work.
To Unlock the Dispenser:
Press and hold the LOCK OUT button for 2 seconds until the
indicator disappears. Then continue to dispense water as usual.
@
LOCK O UT
13