Troubleshooting - Kenmore Top-mount Refrigerator Use & Care Manual

Top-mount refrigerator
Hide thumbs Also See for Kenmore Top-mount Refrigerator:
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
Try the solutions suggested
hers first in order to avoid the cost of an unnecessary
service call.
Your refrigerator
will not operate
The refrigerator
seems to make too much noise
Is the power cord unplugged? Plug into a grounded 3 prong
The sounds may be normal for your refrigerator. See
outlet.
"Normal Sounds."
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker.
Is the Refrigerator Control turned to the OFF position?
See "Using the Control(s)," depending on the model.
Is the refrigerator defrosting? Recheck to see whether the
refrigerator is operating in 30 minutes. Your refrigerator will
regularly run an automatic defrost cycle.
Is the refrigerator not cooling? For models with digital
controls, turn the refrigerator off and then back on again to
reset. See "Using the Controls." If this does not correct the
problem, call for service.
The lights do not work
Is the power cord unplugged? Plug into a grounded 3 prong
outlet.
Is a light bulb loose in the socket or burned out? See
"Changing the Light Bulb(s)," depending on the model.
There is water in the defrost
drain pan
Is the refrigerator defrosting? The water will evaporate. It is
normal for water to drip into the defrost pan.
Is it more humid than normal? When it is humid, expect that
the water in the defrost pan will take longer to evaporate.
The motor
seems to run too much
Is the room temperature
hotter than normal? The motor
will run longer under warm conditions.
At normal room
temperatures,
your motor will run about 40% to 80% of the
time. Under warmer conditions,
it will run even more.
Has a large amount of food just been added to the
refrigerator?. Adding a large amount of food warms the
refrigerator. The motor normally will run longer to cool the
refrigerator back down.
Are the doors opened often? The motor will run longer
when this occurs. Conserve energy by getting all items out at
one time, keeping food organized, and closing the door as
soon as possible.
Is the control set correctly for the surrounding
conditions? See "Using the Control(s)," depending
on the
model.
The ice maker is not producing
ice or not enough ice
Is the freezer door closed completely? Firmly close the
freezer compartment
door. If the freezer compartment
door
will not close all the way, see "The doors will not close
completely"
later in this section.
Has the ice maker just been installed? Wait 72 hours for full
ice production
to begin. Once your refrigerator is cooled, the
ice maker should produce 70-120 cubes every 24 hours.
Is the freezer temperature
cold enough to produce ice?
Wait 24 hours after hookup for ice production.
See "Using the
Control(s)," depending
on the model.
Is the wire shutoff arm in the OFF (arm up) position?
Lower the wire shutoff arm to the ON (arm down) position.
See "Ice Maker."
Is the water line shutoff valve to the refrigerator turned
on? Turn on the water valve. See "Connect the Water
Supply."
Does the ice maker mold have water in it or has no ice
been produced? Be sure your refrigerator has been
connected to a water supply and the supply shutoff valve is
turned on. See "Connect the Water Supply."
Is an ice cube jammed
in the ejector arm? Remove the ice
from the ejector arm with a plastic utensil. See "Ice Maker."
Has a large amount of ice just been removed? Allow
24 hours for ice maker to produce more ice.
Is the control set correctly?. If too little ice is produced,
see
"Using the Control(s)," depending on the model.
Is there a water filter installed
on the refrigerator?. The
filter may be full or incorrectly installed. Depending on your
model, remove the water filter cartridge. See "Water Filtration
System." Operate the dispenser. If the water flow increases
noticeably, your filter is full and needs to be replaced.
Is a reverse osmosis water filtration
system connected to
your cold water supply? See "Water Supply Requirements,"
NOTE: If not due to any of the above, there may be a problem
with the water line. Call for service.
Are the doors closed completely? Close the doors firmly. If
they do not close completely, see "The doors will not close
completely"
later in this section.
NOTE: Your new refrigerator will run longer than your old one due
to its high-efficiency
motor.
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite 106. series

Table of Contents