System Cover; Installing The Bezel; Removing The Cover; Installing The Cover - Dell PowerEdge 1600SC Systems Istallation And Troubleshooting Manual

Hide thumbs Also See for PowerEdge 1600SC:

Table of Contents

1. Snap the two tabs on the lower inside edge of the bezel into the corresponding clips on the system front panel, and pivot the bezel upward to its

closed position.

2. Using the system key, lock the bezel.

System Cover

To upgrade or troubleshoot the system, remove the cover to gain access to internal components.

CAUTION:

Before you perform this procedure, see

1. Remove the bezel (see

"Removing the

2. Loosen the three thumbscrews on the left-side cover (see Figure 5-3).

3. Grasp the cover at both ends and slide it toward the front of the system.

4. Lift the cover away from the system.

Figure 5-3. Removing the Cover

NOTICE:

Figure 5-3

shows the system standing upright as the cover is being removed. However, before you service components inside the system, lay

the system on its right side.

1. Ensure that no tools or loose parts are left inside the system.

2. Fit the cover on the side of the system, and slide the cover backward.

3. Tighten the three cover thumbscrews (see Figure 5-3).

4. Replace the bezel.

Baffle

"Safety First—For You and Your

Bezel").

System."

Table of Contents