System Cover; Removing The System Cover - Dell EMC PowerEdge MX740c Installation And Service Manual

Figure 15. Installing the sled into enclosure
Next steps
1. Power on the sled.

System cover

The system cover protects the components inside the system and helps in maintaining air flow inside the system.

Removing the system cover

Prerequisites
1. Follow the safety guidelines listedin
2. Power off the sled.
3. Remove the sled from the
4. Place the sled on the flat surface with the top cover facing upwards.
Steps
1. Press the blue release tab on the system cover and slide the cover towards the rear of the system.
2. Hold the cover on both sides, and lift the cover away from the system.
20 Installing and removing system components
Safety instructions
enclosure.
on page 16.