Kenmore 580.73089 Owner's Manual page 7

I_1 Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
I_1 Placa the sill supports with the cabinet on the
window sill's selected position.
l_The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
ITEM B FIG. 11
B Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front angre into the
window inner sill (FIG. 12).
ITEMB
Track
_er Guide
ITEM F
FIG. 12
i_ Pull each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G), (FIG. 13)
ITEM G
FIG. 13
B Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
_J DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
downward to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
"_BASE PAN REAR
DRAIN_,..j_
'_77_S_0M FIG. 15
B Slide the chassis into the cabinet, (FIG, 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1,
Cord
-7-
Screw
Screw FIG. 16
r_cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
FIG. 17
_-'_The vent control handle must be straightened
before the decorative front is attached.
Pull out part ® to align with part _.
_FIG. 18