Changing Configuration Parameters - Compaq 2000 Series UPS Operation And Reference Manual

4-6 Compaq 2000 Series UPS Operation and Reference Guide

Changing Configuration Parameters

The Configure mode can be entered from the Operate or Standby mode.
IMPORTANT: If the STANDBY button is pressed while in the Configure mode, the UPS will
enter Standby mode, and power to the load segments will cease.
Figure 4-3. Configure mode controls
ON LED (LED 16)
ON button
STANDBY button
TEST/ALARM RESET button
To change configuration parameters:
1. Place the UPS in Configure mode by pressing the ON ( ) and
TEST/ALARM RESET ( ) buttons simultaneously. Release the buttons
when the acknowledgement beep sounds.
2. The top left LED on the front panel LED display should begin to blink,
indicating that configuration parameter 1 is selected.
3. To determine if the selected configuration parameter value is ON or
OFF, check LED 16 ( )—if LED 16 is ON, the selected parameter is
also ON.
4. To toggle the selected configuration parameter value, press the
TEST/ALARM RESET button ( ). The UPS will acknowledge
compliance with a short beep.
1
2
3
4