Changing Configuration Parameters - Compaq T2200 XR Operation And Reference Manual

Changing Configuration Parameters

The Configure mode may be entered from the Operate or Standby mode.
Figure 4-4. Configure mode controls and Configuration parameter LED display
Configure mode button controls
1
ON button
(advances to next configurable option setting)
2
STANDBY button
(accepts flashing voltage configuration;
toggles Site Wiring Fault option)
3
TEST/ALARM RESET button
(exits Configure mode)
4
Configure mode ON LED
5
Configure button
To change configuration parameters:
1. To place the UPS in Configure mode, press the Configure button (5)
until the Configure mode ON LED (4) turns solid green.
2. When the Configure button is released, the configurable LEDs will flash
and the configured LEDs are indicated by solid illumination.
1 2 3
4
5
Configuration parameter LED display
General Alarm
On Battery
Bad Battery/Low Battery
Site Wiring Fault Indicator
Utility LED
Configuration 4-5