Dell 1600n - Multifunction Laser Printer B/W Service Manual page 50

11. Remove the CCD Cable, as shown below.
12. Pull up the CCD Shaft and take out the Scanner
Module.
Scanner Module
Caution:
Assembling Scanner Module
When assembling the scanner module,
the belt and the belt Spring, the belt
spring must be located on the right side
of the scanner module and the parts
should be put as close to each other as
possible as shown below.
13. Push the Belt Holder and take out the Belt, as shown
CCD Cable
14. Remove the Reduction Gear and Idle Gear, as
CCD Shaft
below.
shown below.
Gear-Timing
Precautions
Spring
Belt
Gear-Reduction
Service Manual
5-7