5.8 Middle Cover & Exit Roller
1. Before you remove the Exit Roller, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Scanner Ass'y (see page 5-5)
- Controller Shield Ass'y (see page 5-12)
2. Remove the 6 screws securing the Middle Cover and
remove it.
3. Unlatch the Middle Cover Securing the Frame Ass'y,
using a proper tool as shown below. Then up ward the
Top Cover out.
Middle Cover
.4. Remove the Exit Gear and Bearing, as shown below.
Bearing
Exit Gear
Main Frame
Precautions
Exit Roller
Service Manual
5-11